Sikalastic® Primer FPO

Synthetic polymer

9 months from date of production

The product must be stored properly in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C.
Higher storage temperatures may reduce shelf life of product.
Reference shall also be made to the storage recommendations within the safety data sheet.

20–30 mPas (20 °C)

+10 °C min. / +30 °C max.

80 % r.h. max.

Beware of condensation.
The substrate and uncured coating must be ≥3 °C above dew point.

+10 °C min. / +30 °C max.

Visibly free from moisture and condensation

Note: Apply an additional coat if more than 24 hours pass before coating

Times are approximate and will be affected by changing ambient conditions, particularly temperature and relative humidity.

Apply in one coat, at a coverage rate of 70–140 ml/m²

The surfaces must be clean, dry, free of stripping agents and free of oil, grease, silanes, salts, silicone, siloxanes and other chemicals which could cause poor adhesion.

Heavily soiled old membranes to be coated should be thoroughly cleaned by conventional means.
Prior to the application of the Sikalastic® Primer FPO clean with Sarnafil^® T Clean and allow surface to dry for a minimum of 15 minutes at 23 °C and 50 % relative humidity. Depending on climate, curing can be faster or slower.
If in doubt apply a test area first.
 

Shake the can of Sikalastic® Primer FPO very thoroughly.
Apply a thin but completely covering coat of Sikalastic® Primer FPO with a solvent resistant roller or brush. Sikalastic® Primer FPO should be applied once only. Care must be taken to ensure that this single application gives adequate and uniform coverage.
Allow primer to dry sufficiently (see table waiting time / overcoating) before overcoating.