Sika® Trocal C-733
Sika® Trocal C-733 is a 1-part, nitrile rubber based solvented contact adhesive.
- Adheres to solid, rough and clean surfaces
- Application by brush or roller
- Final strength depends on climate during application
Usage
- Bonding Sikaplan® PVC roof waterproofing membranes to substrate at roof edges and junctions
- Concrete, lightweight concrete, brick, plaster
- Oriented strand boards (OSB), plywood panels
- Fibre cement boards
- Mineral fibre boards with sufficient compressive strength and appropriate surface for bonding
- Polyester, hard and soft PVC
- Galvanized steel, aluminium, PVC-coated metal sheet
Advantages
- Adheres to solid, rough and clean surfaces
- Application by brush or roller
- Final strength depends on climate during application
Packaging
One way container: | 5 kg, 20 kg |
Packing unit: | Euro pallet or single container |
Refer to current price list for packaging variations.
Colour
Yellowish
Product Details
Chemical Base
Solvented nitrile rubber
Shelf Life
24 months from date of production
Storage Conditions
The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C. Always refer to packaging.
Density
~0,90 kg/l (+20 °C)
Consistency
Liquid
Compatibility
Shall not be used on substrates:
- EPS/XPS insulation boards
- Copper plate
- Bituminous substrates
These materials could adversely affect the product properties.
Application
Ambient Air Temperature
+5 °C min
Substrate Temperature
+5 °C min
Setting Time
Full adhesion is generally achieved immediately after bonding. This can be affected by ambient conditions.
Consumption
~300–500 g/m2
Consumption depends on the roughness and absorbency of the substrate.
These figures are theoretical and do not allow for any additional material due to surface porosity, surface profile, variations in level or wastage etc.
SUBSTRATE QUALITY
The substrate must offer sufficient strength and adhesion to resist the forces generated by wind suction.
SUBSTRATE PREPARATION
The substrate must be resistant to solvents and must be firm, clean, dry, free from oil, grease dust, stripping agents and loose friable particles.
Absorbent substrates can be primed by diluting the adhesive.
APPLICATION
Reference must be made to further documentation of the relevant roof waterproofing membrane where applicable, such as relevant method statement, application manual and installation or working instructions.
General adhesive information
Sika-Trocal® C 733 must be stirred carefully before use. Keep adhesive container closed whenever adhesive is not being used to keep workability consistant (to reduce solvent evaporation).
Viscosity of the Sika-Trocal® C 733 contact adhesive can be changed and adapted by adding Sika-Trocal® Cleaner L 100. It may be necessary to modify the viscosity after prolonged storage or if container was opened for long periods of time. Mix Sika-Trocal® Cleaner L 100 into the adhesive by carefully stirring small quantities into the adhesive to achieve the desired viscosity.
Bonding procedure
The adhesive is spread evenly onto the substrate using a roller. Do not apply the adhesive to an area greater than can be covered in one day. Allow the adhesive to dry completely. Apply 2 coats of adhesive on absorbent substrates (the first coat must have dried out completely before the second is applied).
Apply the adhesive evenly on the underside of the roof membrane (note: welding seam overlap area must be free of adhesive). Once the adhesive has been allowed to evaporate sufficiently (finger test), apply the membrane onto the substrate adhesive. Press down firmly on the membrane using a roller.
CLEANING OF TOOLS
Clean all tools and application equipment with Sika-Trocal® Cleaner L 100 immediately after use. Hardened material can only be removed mechanically.