Sikagard®-675 W GB ElastoColor

Conforms to the requirements of EN 1504-2.

Reaction to fire classification B-s1, d0 in accordance with BS EN 13501-1:2018.

Complies with the requirements of A2-s1,d0 reaction to fire in accordance with BS EN 13501-1:2018 (please contact Sika Technical Services for more information on system build up requirements).

12 months

Store in cool and dry conditions. Protect from direct sunlight and frost.

~1.42 kg/l (at +20 °C)

~64 %

~48 %

Normal absorbent concrete and/or well cured thin layer Sika^® renders (Sika^® MonoTop^®-3020, etc.):

Smooth, non-absorbent concrete:

Absorbent fair-faced concrete:

Water splash zones, de-icing salt exposure:

Varied types of substrates, dense or weak, tensile strength < 1 MPa:

All substrates:

* Note: With yellow or red colour shade variations and/or dark substrates, more than two coats may be required. Trials are advised. Refer to relevant Product Data Sheets within the system.

Pass after 2000 hours

As part of an A2-s1,d0 system is achieveable (please contact Sika Technical Services for system build-up information).

Minimum required dry film thickness (DFT) to achieve full durability characteristics (CO₂ diffusion, adhesion after thermal cycling, etc.) ≈ 160 microns.

+8 °C minimum / +35 °C maximum

<80 %

Substrate and ambient temperature must be at least 3 °C above dew point.

+8 °C minimum / +35 °C maximum

Waiting time between coats at +20 °C substrate temperature:

Note: A refresher coat of Sikagard®-675 GB W ElastoColor can be applied without priming if the existing coat has been thoroughly cleaned.

Final drying: ~24 hours at +20 °C

• Sikagard®-675 W GB ElastoColor is supplied ready for use.
• If required, apply appropriate primer to substrate (refer to coating system structure).
• Sikagard®-675 W GB ElastoColor can be applied by brush, roller or airless spray.
• For airless spray application: Pressure: ~150 bar. Nozzle bore: 0.38–0.53 mm. Spray angle: ~50–80°.

Clean all tools and application equipment with water immediately after use. Hardened / cured material can only be removed mechanically. For Sikagard®-551 S Elastic Primer, use Sika® Thinner C.