Sikagard®-675 W ElastoColor

• LPM report A-33’884-2 dated 21st July 2009
• Tested to OS-C system of ZTV-SIC 90 – Polymer Institute report P 3169-2 dated 15th. 07.2003
• Reaction to fire report – MPA Desden, Germany No. 06-6-2069/02 dated 1st August 2006
• Protective coating according to EN 1504-2, DoP 02 03 03 03 001 0 000003 1125; certified by Factory Production Control Body: 0921; certificate 0921-BPR-2046 and provided with the CE-mark

Styrene acrylate dispersion

12 months from date of production if stored properly in undamaged and unopened original sealed packaging.

Store in cool and dry conditions. Protect from direct sunlight and frost.

~1.30 kg/l (at +20 °C)

~57%

~ 43%

Normal absorbent concrete and/or well cured thin layer Sika renders
(Sika MonoTop^®-723 N, Sika^® Icoment-520 etc.):

Smooth non-absorbent concrete:

Absorbent fair faced concrete:

Splash zones, concrete exposed to de-icing salts splashes:

For all substrates:

Note*:

With intensive yellow or red colour and/or a dart substrate, more than two coats may be required.

Pass after 2000 hours

Minimum required dry thickness to achieve full durability characteristics
(CO₂ diffusion, adhesion after thermal cycling, etc.) ≈ 180 microns.

+8 °C min. / +35 °C max.

< 80%

Substrate and ambient temperature must be at least 3 °C above dew point.

+8 °C min. / +35 °C max.

Waiting time between coats at +20 °C substrate temperature:

Note: A refresher coat of Sikagard®-675 W ElastoColor can be applied without priming if the existing coat has been thoroughly cleaned.

Sikagard®-675 W ElastoColor does not require any special curing but must be protected from rain for at least 2 hours at +20 °C.

Final drying: ~14 hours at +20 °C

Sikagard®-675 W ElastoColor is supplied ready for use and must be not thinned unless the 1^st coat is used as a primer (refer to coating system structures). In these instances, add up to 15% of water and mix thoroughly. Un-thinned material must be stirred up thoroughly prior to application.
 
Sikagard®-675 W ElastoColor can be applied by brush, roller or airless spray.
For airless spray application:
Pressure: ~150 bar
Nozzle bore: 0.38–0.53 mm
Spray angle: ~50–80°

Clean all tools and application equipment with water immediately after use. Hardened / cured material can only be removed mechanically.
For Sikagard®-551 S Elastic Primer use Sika® Thinner C.