Sikagard®-670 W Elastocolor

Product for protection against the penetration, humidity control and resistivity increase (coating) following EN 1504-2:2004, with Declaration of Performance 01 03 03 03 006 0 0000001 1053, with the certificate of conformity of the factory production control number 0099/CPR/B15/0007

Water dispersed acrylic resins

12 months from date of production

 If stored properly in undamaged and unopened, original sealed packaging in dry and cool conditions, protected from frosts.

~ 1,30 kg/l ( at +20ºC)

~45% by weight

~60% by volume

Normal Conditions:

Absorbent sustrates

Marine environments, exposed concrete to dicing salts

Note: may need a third layer of Sikagard®-670 W Elastocolor depending of the porosity of the substrate or applied over a previous dark coating (well adhered)

For normal use Sikagard®-670 W Elastocolor is supplied ready to use.
Stir thoroughly prior to application

In case of very high or very low temperatures the viscosity can be adjusted by adding a 2% water, previously removing their use.

If absorbent substrates, dilute the product by 5% maximum water, mix the product well before applying.

Mín 60 micron (by layer)
Máx.120 micron (by layer)

+8º C min / +35º C max

< 80%

+8º C min / +35º C max

Note: can be applied without priming if the existing coat has been througly cleaned

Full cure:~4 hours at +23ºC

Sikagard®-670 W Elastocolor can be manually applied by paintbrush or short piled roller or mechanically by «air-less».
The second layer product must be applied in perpendicular to the first direction to
achieve an optimal opacity.

For projection equipment airless, use the following:

• ~ 150bar pressure
• ~ 0.38 to 0.53 mm nozzle
• Application angle ~ 50-80

Clean all tools and application equipment with clean water immediately after use.
Hardened / cured material can only be removed mechanically