Product Data Sheet Show all documents
EVERBUILD® P16 PVC Pipe Cement

EVERBUILD® P16 PVC Pipe Cement

Non-drip, solvent-based pipe cement for use with PVC and ABS

EVERBUILD® P16 PVC Pipe Cement is a non-drip, thixotropic solvent-based pipe cement for use with non-pressure PVC and ABS thermoplastic pipes and conduits. EVERBUILD® P16 PVC Pipe Cement combines a long open time with a rapid rate of bond strength development, enabling assembled units to be handled and put into service with a minimum delay.

  • Rapid bond strength development
  • Easy-to-apply thixotropic paste
  • Non-drip gel formula
Ask for a quote
Product Data Sheet Show all documents

Usage

The product is designed specifically for the following:
  • Bonding uPVC Pipes and accessories in pressure systems up to 16PN according to BSEN 14814, specifically for bonding thermoplastic piping systems that conform to BSEN 1329.
  • Bonding Pipes and accessories in waste systems according to the following standards:
    • PVC-U plastic piping systems for soil and waste discharge (low and high temperature) - BSEN 1329.
    •  ABS piping systems for soil and waste discharge (low and high temperature) - BSEN 1455.
 

Advantages

  • Rapid bond strength development
  • Easy-to-apply thixotropic paste
  • Non-drip gel formula

Packaging

250ml plastic tub

Colour

Clear

Product Details

Sustainability / Certifications / Approvals

APPROVALS / STANDARDS

Conforms to CE mark BSEN 14814 and Kite mark BSEN 14680
Product Information

Shelf Life

12 months from the date of manufacture

Storage Conditions

Store in original unopened containers in a cool (+5°C to +35°C) dry area out of direct sunlight. Protect from frost.

Density

0.87 g/cm3 at 20 °C

Application

Consumption

Yield

Approx. 0.6m² per 250ml when applied as directed i.e. enough for 31 x 32mm diameter joints or 6 x 90mm joints.

 
Application steps

SUBSTRATE PREPARATION

Wear suitable protective clothing and gloves before use. Avoid inhalation of vapours and extinguish all sources of ignition. Use in a well-ventilated area.

All surfaces to be joined must be clean, sound and dry. Cut pipes squarely. Remove any swarf and chamfer the outside edge. Lightly abrade pipe with emery cloth and degrease with a proprietary solvent such as Stick2® Contact Adhesive Thinner and Cleaner. Check the two ends fit together correctly.

Documents