Sikadur®-33

Testing according to EN 1504-4.

Epoxy resin.

12 months from date of production if stored properly in undamaged and unopened.  On each Sikadur®-33 cartridge the best before date is printed.

Cool and dry conditions, at temperatures between
+10°C and +30°C. Protect from direct sunlight.

1.35 kg/l (part A+B mixed)

*100% concrete failure
**100% brick failure

Hardens without shrinkage.

Part A : part B = 1 : 1 by volume

0.5 mm min. / 10 mm max.

Non-sag, suitable for overhead application

+10°C min. / +35°C max.

Avoid condensation during dew point conditions.  Substrate temperature during application must be at least 3°C above dew point.

+10°C min. / +35°C max.

Substrate must be dry or mat damp (no standing water)

60 minutes (+23°C)

* to achieve approx. 80% of the performance
Min. cartridge temperature +10°C

Mortar and concrete must be older than 28 days.
Adequate substrate strength (concrete, masonry, natural stone) must always be confirmed.

Getting the cartridge ready

• Unscrew and remove the cap
• Pull out the plug
• Screw on the static mixer
• Place the cartridge into the gun and start application

Important note:  When the work is interrupted the static mixer can remain on the cartridge after the
gun pressure has been relieved. If the resin has hardened in the nozzle when work
is resumed, a new nozzle must be attached.

Clean all tools and application equipment with Sika® Thinner C immediately after use. Hardened / curded material can only be mechanically removed.