Sikafloor®-54 Booster

Curing agent catalyst based on tertiary amine

24 months from date of production 

The product must be stored properly in original, unopened and undamaged sealed packaging, in dry conditions at temperatures between +5 °C and +30 °C.

Workable dosage:

Refer to the specific product data sheet

Refer to the specific product data sheet

Beware of condensation! The substrate and uncured floor must be at least 3 °C above dew point to reduce the risk of condensation or blooming on the floor finish.

Note: Low temperatures and high humidity conditions increase the probability of blooming.

Refer to the specific product data sheet

< 4 % pbw moisture content using the Sika®-Tramex meter (at the time of application). Test method: Sika®-Tramex meter, CM-measurement or oven-dry-method. No rising moisture according to ASTM (Polyethylene-sheet).

When Sikafloor®-54 Booster is added to Sikafloor®-156 /-161 allow:

Times are approximate and will be affected by changing ambient conditions particularly temperature and relative humidity.

Add Sikafloor®-54 Booster to Sikafloor®-156 /-161 on site at the time of application. Prior to mixing, stir part A mechanically. When all of part B has been added to part A, mix continuously for 3 minutes until a uniform mix has been achieved. When parts A and B have been mixed, add the Sikafloor®-54 Booster and mix for another further 2 minutes until a uniform mix has been achieved. To ensure thorough mixing pour materials into another container and mix again to achieve a consistent mix. Over mixing must be avoided to minimise air entrainment.

Mixing Tools

Use a low speed electric stirrer (300 - 400 rpm) or other suitable equipment.

Refer to the specific product data sheet