Product Data Sheet Show all documents

Sika® Patio Seal

An easily applied, water based sealer and appearance enhancer for new and recently cleaned paving.

Sika® Patio Seal is a low odour water based acrylic coating used to seal and protect patios, paths, natural stone, concrete and  block paving from the effects of sunlight, water, oil, petrol and organic growth. The milky solution dries to hard wearing water repellent film which gives a low sheen slip resistant finish which will reduce dirt pickup and facilitate easier cleaning. The product is safer to use than conventional solvent based products, i.e. it is non- flammable and will not harm plants and animals when used as directed.

  • Water based formulation – non-flammable, low odour.
  • Improves appearance of paths/stone.
  • Also acts as a dustproofer and facilitates easier cleaning.
  • Dramatically improves water and mark resistance - High degree of water repellency in dried film.
  • Contains a fungicide – prevents unsightly growth in the film
  • Easily cleaned with a simple detergent wash.
M.F.F.T ca. 0°C
Product Data Sheet Show all documents

Usage

  • Paths,
  • Patios,
  • Natural stone,
  • Concrete and block paving where it will protect from the effects of sunlight, water, oil, petrol and organic growth.
 

Advantages

  • Water based formulation – non-flammable, low odour.
  • Improves appearance of paths/stone.
  • Also acts as a dustproofer and facilitates easier cleaning.
  • Dramatically improves water and mark resistance - High degree of water repellency in dried film.
  • Contains a fungicide – prevents unsightly growth in the film
  • Easily cleaned with a simple detergent wash.
M.F.F.T ca. 0°C

Packaging

5Ltr Jerry can

Colour

White emulsion, dries clear

Product Details

Product Information

Shelf Life

12 months when stored according to manufacturers instructions.

Storage Conditions

Store at moderate (5 - 30°C) temperatures in original containers. PROTECT FROM FROST.

Density

ca. 1.01 g/cm³

Solid Content

ca. 14% w/w

Application

Application Information

Drying time

4 hours
Consumption

Consumption

1 Litre will cover approximately 8m² per coat depending on nature of surface
Application steps

APPLICATION

Stir well before use. May be applied to damp (but not wet) surfaces. Apply using a long pile roller and tray or low-pressure spray. Ensure even and thorough coverage, especially on textured finishes where ponding of the material MUST be avoided. Apply in two coats, allowing no more than 2 hours between coats. An extra coat may be applied if a semi gloss finish is required. Drying time will be 4 hours from last coat at 20°C. This will be extended at lower temperatures. Do not apply below 5°C.

CLEANING

Areas treated with this product can be cleaned with warm water and detergent or SIKA MOULD BUSTER. Do not use acid based cleaners, as these will remove/discolour the product. Avoid using power washes.

Documents