Product Data Sheet Show all documents

EVERBUILD® GRIPTITE®

An extra-tough high grab construction adhesive

EVERBUILD® GRIPTITE® is a ready to use gap filling and panel adhesive based on a high bond strength synthetic rubber/resin mix in a solvent carrier. Adheres to most common surfaces inside and outside the home. Bonds to wood, plaster, plasterboard, carpet, carpet grippers, metal, glass, ceramics, brick, concrete, cork, uPVC and certain plastics.

  • Solvent based formula - quick drying / high early bond strength.
  • Excellent adhesion/bond strength - adheres to most common surfaces.
  • Good early grab properties - usable both horizontally and vertically
  • High solids formulation - excellent gap filling properties.
  • Suitable for use where both surfaces are non-porous.
  • Excellent external weathering properties - suitable for exterior use
  • Excellent chemical resistance
Viscosity 1,800,000 cP Ash rate 50 +/- 1% VOC 30 +/- 1% Flash point -10°C
Product Data Sheet Show all documents

Usage

  • Bonding dado rails, architrave and skirting
  • Fixing parquet and cork flooring.
  • Fixing wall cladding direct to internal wall surfaces or timber battens.
  • Fixing battens directly onto walls without fastenings.
  • Bonding carpet gripper systems to most floors without the need for nails or tacks.
  • Bonding stair nosing to concrete or wooden stairs.
  • Fixing polyester, wood, PVCu or metal thresholds.
  • Fixing nameplates, plastic boxes, decorative frames, wall sockets and junction boxes to most surfaces.
  • Securing aluminium or other skin panels to the framework or portable industrial buildings and caravans.
 

Advantages

  • Solvent based formula - quick drying / high early bond strength.
  • Excellent adhesion/bond strength - adheres to most common surfaces.
  • Good early grab properties - usable both horizontally and vertically
  • High solids formulation - excellent gap filling properties.
  • Suitable for use where both surfaces are non-porous.
  • Excellent external weathering properties - suitable for exterior use
  • Excellent chemical resistance
Viscosity 1,800,000 cP Ash rate 50 +/- 1% VOC 30 +/- 1% Flash point -10°C

Packaging

Cartridge

Colour

Buff

Product Details

Product Information

Chemical Base

SBR / Hydrocarbon tackifiers in solvent

Shelf Life

12 months from date of manufacture in unopened containers.

Storage Conditions

Store in original unopened containers between 15°C and 20°C. Do not store above 30°C. Store as flammable goods.

Density

1.20 – 1.28 g/cm3

Solid content by weight

70 +/- 1%

Consistency

Paste
Technical Information

Chemical Resistance

Strong bleach, 25% Caustic Soda, 10% Hydrochloric and Sulphuric Acids shown negligible effect on the product following full immersion over 1 week.

Service Temperature

-20°C to 50°C

Application

Application Information

Ambient Air Temperature

+5 to 40°C
Consumption

Yield

Approx 10 linear meters
Application steps

SUBSTRATE PREPARATION

The surfaces to be glued must be clean, dry and free from dust, grease and other contaminants. New concrete or plaster should be allowed adequate time to dry and mature. If this is not possible, use EVERBUILD GUN A NAIL.

Porous or friable surface should first be primed with dilute contact adhesive and allowed to dry.

Documents