Product Data Sheet Show all documents

EVERBUILD® FLOOR PAINT

Heavy duty, polyurethane based floor paint

EVERBUILD® FLOOR PAINT is a solvent-based polyurethane floor paint designed to provide a clean hard wearing finish to concrete, stone and wooden floors subject to light to medium traffic. Ideal for use on garage floors, workshops, storerooms, walkways etc. EVERBUILD® FLOOR PAINT gives enhanced durability, abrasion resistance and a good resistance to dilute acids/alkalis and oils.

  • Hard wearing polyurethane formula.
  • Low viscosity for easy application over large areas.
  • One component solvent based system.
MFFT                                         >5°C Film Thickness (dry)              25 - 40 μm Dry Time (touch dry)             2 - 4 hours Dry Time (between coats)   16 - 24 hours
Product Data Sheet Show all documents

Usage

Concrete, stone and wooden floors in:
  • Garages
  • Workshops
  • Storerooms
  • Cloakrooms and many more.
 

Advantages

  • Hard wearing polyurethane formula.
  • Low viscosity for easy application over large areas.
  • One component solvent based system.
MFFT                                         >5°C Film Thickness (dry)              25 - 40 μm Dry Time (touch dry)             2 - 4 hours Dry Time (between coats)   16 - 24 hours

Packaging

5ltr tins

Colour

Grey, Red

Product Details

Product Information

Chemical Base

Polyurethane

Shelf Life

24 months from date of manufacture when stored correctly in unopened container.

Storage Conditions

Store in cool, dry conditions, between 5 and 25°C. PROTECT FROM FROST.

Application

Application steps

APPLICATION

Concrete must be a minimum of 6 months old before paint can be applied. Priming is not normally required, however the first coat on concrete or porous surfaces should first be thinned with up to 10% white spirit and allowed to dry. EVERBUILD® FLOOR PAINT is touch dry in 2-4 hours depending on ambient temperatures. NOTE low temperatures can significantly extend drying time. Apply using a brush or roller to give an even coating. 2 coats are normally required allowing 16-24 hours between coats.

CLEANING OF TOOLS

Clean tools and brushes with white spirits/turps subs immediately after use. Cured product can only be removed mechanically.

Documents